Search results

  1. G

    Time lag switch for extensions sockets

    I have just moved all my numerous chargers into the garage (drill, strimmer, chopper, 2xcamera, PDA, satnav.... the list goes on) into the garage and put them on a switched 7 gang extension. What I want to be abel to do is switch them on..... but not have to remember to switch them off a) to...
  2. G

    Containing loose stone (slate mulch) poured on old concete

    I have a large amount of concrete in my back garden which is cracked and looks horrible.... but not wanting to 'bite the bullet' and have it all dug up! Some of it is at different levels and there is a large amount!! I am planning on putting slate mulch on it as a nice looking covering...
  3. G

    Attaching wooden battons to concrete

    I am planning on putting loose slate mulch on top of some againg concrete in the garden/patio but want to stop it from sliding off the 'desired' areas. I am planning on putting a thin (about 2cm....I will experiment) wooden ridge around the area in question. (slightly raised up by plastic...
  4. G

    Small area of rendering

    I have to render over a small area above a front door approximately 6inches by 12 inches. It is raised from the surrounding area. What is the best way to do this? I would get someone in but trying to get builders to do things round these parts is difficult enough especially for small jobs...
  5. G

    time delay switch

    I have about 5 or 6 chargers (phone, nintendo, camera etc...) plugged into a extension that is usually left on 24/7 wasting electricity as all thetransformers stay warm even if nothing is plugged in. Does anyone have a solution for this. I was thinking along the lines of a time lag switch...
  6. G

    Labeling od consumer unit

    I recently moved into a house which has a modern consumer unit. However the labels of the various switched do not marry to the circuits. Are there any specific rules I must follow to label a consumer unit? I was thinking of numbering the various switches and then having a list on a...
  7. G

    Decking onto concrete

    I have some, well quite a lot, of unsightly concrete I wish to deck over. Some of it is at different hights, and some is slightly sloped. If I am to build the frame, how do I secure it to the concrete? Do I just rely on the weight of the decking? Also, do I raise the frame off the...
  8. G

    Underfloor heating thermostat location for a bathroom

    I have an option of putting the electric thermostat controller (temp sensor is within the heated floor) either in the loft above the bathroom or in a separate toilet adjacent to the bathroom. If the separate toilet does not have a basin can I put the thermostat controller in there without...
  9. G

    Bathroom extractor fan and dimmer

    Short version of question: can I use the dimmed output of a dimmer to connect to the switched live input of a timed extractor fan? The permanent live and neutral will not come from the dimmer switch (but will come fromt eh lighting circuit) Long version. Here is what I am going to use: 3 x...
  10. G

    Badly fitting windows

    I have bought a house which has old (externally glazed!) upvc double glazed windows in the bays. Two of the five windows of the bay can open. They have side hinges. There is a large gap (0.5cm - you can see sky through it!) at the top of the opening window on the opposite side to the hinges...
Back
Top