Search results

Hi there, I have tried searching for an answer, found similar discussions, but not exactly my problem. Long story short, I would like to not use the pull cord in my bathroom for switching on the lights and fan anymore, (it's old and I just don't like it, ,also doing a bit of redecorating) but...

Two holes in the worktop left after new boiler installation and previous pipework tidied up a bit. Both 22mm. One has a cable from an electronic water conditioner running through it. Best way of sealing/covering them? Foam and paint, silicone and paint, epoxy resins? They're both next to the...

Hi, Looking for some advice. Have made a bath panel from some plywood to which I have added some auto adhesive vinyl planks to somehow match the floor, hope they're almost as good as the LVT flooring and won't come off. At the bottom I have placed a small plinth which is siliconed all around...

Hi, this is my second thread about the same boiler on this forum, which I believe says a lot already. But still looking for some advice. Roughly 10 years old Remeha combi boiler, we moved in 2 years ago and have so far replaced PRV, pressure gauge, expansion vessel and the last one was a...

Hello again, after seeing my previous thread about the boiler leak was closed, issue which by the way was resolved after my gas engineer replaced both the diverter block and the actuator, it didn't make sense to replace just a cartridge inside the diverter block as it was all covered in rust and...

Hello and nice to meet you all. I have searched the forum, but couldn't find a suitable answer, so here it goes. As the title says, my boiler is leaking. Good news is I know where the leak is coming from, bad news it will take probably 2-3 days to get the issue resolved, all gas engineers...