faulty

  1. P

    Should the spindle of a water pump be immovable and static?

    Hello everyone, I'm hoping you can give me some guidance on a long going issue with my boiler. It is an 18 year old Glow worm 24 ci. About 3 weeks ago my boiler decided to fart up and stopped working, called the gas engineer, diagnosed the issue, PCB was faulty. Quoted £350 for a replacement...
  2. lateintheday

    Honeywell CM927 thermostat ~ Faulty button.

    Hello, I've had this Honeywell CM927 thermostat for a few years from new. The temperature up button has gradually become less and less responsive over the years. I now have to press it really hard and at a very specific angle to turn the temperature up. All other buttons are fine. I've taken...
  3. K

    Poor Service (plumber left leaks)

    Hello, please can anyone offer advice? We recently had a new vanity unit, bath panel and radiator installed by a local plumber. He charged us £350 for labour and £50 for small consumables and new tap. He asked for a deposit upfront, which we paid. He then proceeded to swap and change his dates...
  4. martinwb

    Dimplex Duoheat

    Hi folks, My house is up for sale and due to complete in a few weeks time. It has been vacant for a few months and noticed that the Livingroom Dimplex Duoheat (14 years old) has no lights on the control panel (top right 10 lights). The heater has two power supplies and an electrician that has...
  5. L

    Worcester boiler eco mode turning itself off

    I have recently been setting my boiler on eco mode and it stays on that mode until first thing in the morning, when, at some point, the eco mode stops and pre-heating starts. I haven't been able to catch it the moment the eco switches off. When I spot it I switch it on again. What is happening...
  6. M

    Honeywell ADE G4 Alarm - sounding on closed zones

    Hi all, I have recently fitted a honeywell G4 system and it keeps tripping reporting zone 4 and sometimes zone 4 and 5. BUT both these zones are terminated with no sensors. The alarm sets fine but then sounds an hour later for no apparent reason. Could the panel be faulty fresh out of the...
  7. nmg196

    Freezer only just about gets to 0C when set to -20C

    Hi all, My Samsung American style fridge freezer has started to struggle to actually get cold. We noticed stuff in the freezer wasn't always completely frozen so tested with a thermometer to find it was only around -3C and sometimes even warmer! The thermostat's resistance vs temp shows it's...
  8. H

    Hotpoint Aquarius WDL540P - Starts but then stops - Any ideas ?

    We are having problems with our Hotpoint Aquarius WDL540P washer dryer. It will power on without any warning lights. We can select the programme, and start. It starts to fill with water and the drum starts turning. After a very short time it stops turning and nothing then happens at all...
  9. D

    wrongly wired oil filled radiator??

    Hi, I recently bought two new identical oil filled radiators off ebay. Both of them dont seem to work correctly. They have three heat settings 850w, 1750w and 2600w ( 850w and 1750w combined). On the 850w setting the unit works fine, it heats up and responds to the dial thermostat and...
  10. G

    Salus rt500rf receiver faulty - red light but no green light

    Hello, complete novice here.. after doing some searching I found an old post which has alerted me to the fact that the problem with my boiler not responding to the salus rt500rf thermostat display monitor is most likely the receiver, as it is displaying the red light (& is therefore receiving...
Back
Top