• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

pipework

  1. C

    What pipe sizes for completely new hot and cold water system?

    I'm renovating an old victorian 3 floor terraced house with the usual hellish mish-mash of pipework running in bizarre and ugly locations. I want to replace all that with new pipework while I have the floorboards up. My question is, what pipe sizes should I use for the different bits? The...
  2. P

    Flashing over waste pipes leak

    Hi All, My Grandads house has an veranda out the back that goes under the upstairs bathroom. The waste pipes from the sink and toilet then head down into the roof. This appears to have not been flashed correct. See image below. Could you recommend the best way to fix this? I was going to see if...
  3. A

    Can pipes under a combi boiler be moved?

    I have just bought a flat, which has the pictured combi boiler installed in an airing cupboard. As shown in the photo, the installation has a large number of crossing pipes, some of which appear to go down under the floor and some of which go right to the kitchen (and towards the gas meter)...
  4. C

    Cold water supply design

    Hi All, I am totally renovating my home i've just bought. We've ripped out al the plumbing plus had a new 25mm MPDE water main installed with good pressure. We're doing a loft conversion so there will be a total of 3 floors with 2 bathrooms (1 on each upper level). I am trying to design the...
  5. Z

    Dishwasher- aqua stop hose cannot connect to cold pipe, due to the Aqua stop device!

    Hi, several hours later and at the risk of wrecking something here is my post. Bought a dishwasher with an aqua stop device fitted on it, didn't realise it would be an issue however I can't get it to connect to the cold fill hose due to the device getting in the way. I've tried nudging both...
Back
Top