premier elite

Hi, I've recently self installed a Premier Elite 64-W. I'm now looking at integrating it with Home Assistant (I've got no interest in using the Texecom mobile app, just HA) From what I've read I think I can use SmartCom or ComIP for HA, and the SmartCom seems a lot cheaper. But what else am I...

I’m planning to upgrade my Texecom Veritas R8 system to a Texecom Premier Elite 64W, retaining the existing Texecom bellbox. Obviously the bellbox will be staying in situ, with just the control panel/keypads being changed for the new one. My concern is whether the bellbox will go off during...

Hi everyone, I'm in a bit of a bind with my alarm! I had a texecom premier alarm fitted a few years ago to replace an ancient alarm system in my house. Whilst the engineer I had to fit it is a good guy, he's EXTREMELY difficult to get hold of. Often working long periods away and not responding...

Hi, I have seen some good articles on here so hopefully you can help me. I have just wired a new PIR to my Texecom Premier Elite 24 panel. The PIR I am wiring is a 'Premier Elite MR'. I copied the same wiring as my existing three PIRs but I am getting a Tamper error. I have seen some...

Hi, I’ve added several pirs to my alarm. They all trigger the alarm when in part arm or full armed mode. however the latest I have added only sets the alarm off when on full arm. the zones on the keypad for the working and non working pirs are identical. Could anyone point me where to make...

I have suddenly started getting a tamper issue with my Premier Elite Micro Shock Wireless sensor. I have checked the device and the cover is on fine however it will randomly trigger the sensor alarm. Does anyone know why this might be? Resetting the tamper fault will fix it for a couple of...

Hi all.. I recently bought a Texecom Premier Elite 64W. I have 4 core cabling in certain areas throughout the house for the pir sensors and then various other places such as the garage but since have had an outbuilding built and new doors which i wanted to add some wireless detectors to hence...

Despite following what it says in the PDF ie power down the panel - disconnect all from the comm ports When flashing via the port (pin1 in the right orientation) it failed to flash and the panel deadish - The power was applied once the USB Jac001 was in place and set to prog. with no power on...

Hello, Texecom Premier Elite 88 Texecom Premier Elite LCDLP Can someone please point me in the direction of how to configure some zones to chime but only within a specified time frame? I would like to have some door contacts chime only between 6pm and 6am, outside of that time there should be...

Just wondering if anyone else has experienced same issue. I fitted a premier elite wireless system just over 3 years ago. After about a year I had a battery fault on the internal sounder. Took the 8 lithium batteries out and tested them 7 were at 1.7v or above, one was 0.1v. Now after...

Hi All, I m having a right nightmare with Wintex and setting my night timer. Its simple what i need however whenever i set the times all it does is say Time Arming A......... lots of bleeps over the 10 minute test and then it just unarms and the log shows the set and unset but when i am...

I can receive notifications via email no problem but the notifications via the app have stopped working-how do I restore them? I've done the basics and ensured that I have notifications ticked on the app and my phone hasn't blocked them.

Is there any way to remove the insistence when disarming by a user who has a tag the use of the tag and to use their number instead? It gets really annoying especially if I'm with the wife and only one of us has keys/the tag with us and you're unloading the car etc.