Morning all.
Well im pleased to report that I'm getting the chance to practice of loads of old off cuts before I take it to my actual project.
As I learn more about routing I'm getting more used to the terms. Aside from t trim I'm also looking at cutting a channel on the face of the board to slide some hardboard into.
For that I take it I need a straight bit? But I notice some are fluted, is this better/worse or a different type of bit altogether?
Thanks as always!
Well im pleased to report that I'm getting the chance to practice of loads of old off cuts before I take it to my actual project.
As I learn more about routing I'm getting more used to the terms. Aside from t trim I'm also looking at cutting a channel on the face of the board to slide some hardboard into.
For that I take it I need a straight bit? But I notice some are fluted, is this better/worse or a different type of bit altogether?
Thanks as always!
