Just changed my alarm panel and remote to the Accenta.
Having a problem getting it to set to recognise the new codes. when the power is restored it accepts the new code to stop the actual alarm sounding, then it shows ' Tamper Fault Lockout'. when you put in user 1 & 2 codes it says incorrect codes, but will accept the new engineer code.
we don't seem to be able to get past the information on page 15 of the engieers guide about the tamper fault lock out, but it has let us progam it.
Currently going through checking all the wiring again
Having a problem getting it to set to recognise the new codes. when the power is restored it accepts the new code to stop the actual alarm sounding, then it shows ' Tamper Fault Lockout'. when you put in user 1 & 2 codes it says incorrect codes, but will accept the new engineer code.
we don't seem to be able to get past the information on page 15 of the engieers guide about the tamper fault lock out, but it has let us progam it.
Currently going through checking all the wiring again