Hi there, my neighbour's alarm went off and wouldn't shut up. Knocking on the door didn't help so I was about to go at it with a 2x4 thinking the property was empty when the door opened and a lady popped out. (No not like that).
OK story over, tech bit.
The panel was lit but the day, power and tamper lights on the keypad (remote version ) weren't.
Panel looked slightly open on the clip side which I thought might have set it off.
Tried the factory user code, wouldn't work and she didn't know the current usser code (if there is one). Engineer reset didn't work either. Finally disconnected the bell wires and battery which shut the mother up, decided to leave the strobe going so they remember to do something about it.
Being neighbourly I thought I'd find out how to reset it and why those lights (day, etc) aren't lit.
Any suggestions welcome.
I'm off to bed now 01:23hrs
OK story over, tech bit.
The panel was lit but the day, power and tamper lights on the keypad (remote version ) weren't.
Panel looked slightly open on the clip side which I thought might have set it off.
Tried the factory user code, wouldn't work and she didn't know the current usser code (if there is one). Engineer reset didn't work either. Finally disconnected the bell wires and battery which shut the mother up, decided to leave the strobe going so they remember to do something about it.
Being neighbourly I thought I'd find out how to reset it and why those lights (day, etc) aren't lit.
Any suggestions welcome.
I'm off to bed now 01:23hrs