Hi,
I need to add a socket to a ring. I have located the wire but there is no slack on either side - it will become the first socket off the CU.
Are there any sockets out there that have the wires connect at the ends (in one side and out of the other) rather than both meeting in the middle where it would be difficult the wire without any slack.
I am looking to not have to chase it back to the CU and removing loads of plaster.
Many thanks,
Jack
I need to add a socket to a ring. I have located the wire but there is no slack on either side - it will become the first socket off the CU.
Are there any sockets out there that have the wires connect at the ends (in one side and out of the other) rather than both meeting in the middle where it would be difficult the wire without any slack.
I am looking to not have to chase it back to the CU and removing loads of plaster.
Many thanks,
Jack