Need to add a zone valve (22mm) to a straight bit of 15mm pipe that's about 1m long.
I'm using a one piece reducing set.
Question.... How on earth am I going to put the zone valve in the middle when I cut out a section of pipe? There is very little movement in the pipes?
Even if I was using 22mm pipe, I can't see how it can be done, unless the pipe doesn't need to enter (until it can't go any further) into the valve?
Thanks
Stuart
I'm using a one piece reducing set.
Question.... How on earth am I going to put the zone valve in the middle when I cut out a section of pipe? There is very little movement in the pipes?
Even if I was using 22mm pipe, I can't see how it can be done, unless the pipe doesn't need to enter (until it can't go any further) into the valve?
Thanks
Stuart