Hello,
I previously made my own router table from some help from people off here (Thanks Again!). However the perspex has scratched away at the wood from the vibration and has caused it to sag and now I don't have a level surface. I did find that it was a bit of a problem to change the height continually taking it out and putting it back in again was a nightmare.
Is there a way of adjusting the DW622K from above the table? If so how would this be done?
Thanks
James
I previously made my own router table from some help from people off here (Thanks Again!). However the perspex has scratched away at the wood from the vibration and has caused it to sag and now I don't have a level surface. I did find that it was a bit of a problem to change the height continually taking it out and putting it back in again was a nightmare.
Is there a way of adjusting the DW622K from above the table? If so how would this be done?
Thanks
James