the control box on my scantronic 9450 alarm is very hot on the top surface, not too hot to touch but significantly hot. My wife is concerned that it may burst into flames. I could pull the fuse, to disable the box, but would need to delve inside to disconnect battery. Tomorrow I’ll arrange an engineer, but are my wife’s concerns valid. The system is over 30 yr old but has worked perfectly well in all that time.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Alarm control box hot
- Thread starter Bayardmm
- Start date
Likely, the battery is dead, and is taking a full charge, which it is turning into heat.
Open panel , put in code to stop internal tamper alarm , unplug battery ( spade terminals ) and remove it …If the battery is hot this will be the cause ….the panel heat sink on the top should cool down after about 15 min , close panel and enter code to reset , replace battery 2.1ah type
You can get that battery up to 3.0ah ….its the physical size that matters ….bigger the ah the longer it will last …
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
