Alarm Pin Drop

Joined
21 Dec 2010
Messages
12
Reaction score
0
Location
Lancashire
Country
United Kingdom
My brother said his alarm had gone crazy so i had a look at it and it was all red. Not responding to the usual reset, i ripped out the battery and fuse and the box was still going (as it has its own battery unit).

I noticed at the bottom of the box there was a U shaped pin that i assume has dropped out. Can anyone use their eagle eyes and spot where the pin went?

i have not traced any wires and if i do i would be one step closer to ripping out this box and replacing it with a texecom because whoever installed this box put it in the most inconvenient place ever and i need a keypad.

Thanks in adv
 

Attachments

  • 20190422_161716.jpg
    20190422_161716.jpg
    260.5 KB · Views: 206
What light / lights where lit ?
How old is the battery ? Was there a power cut ?
What shows now when you try to reset it ? ( make sure front is back on )
The link was probably a spare in the bottom of the panel ....
 
What light / lights where lit ?
ALL Lights on the alarm box (when cover is on) is red

How old is the battery ? Was there a power cut ?
The battery is about 6 years old, no issues with it and it still working fine. Power was cut twice. When the alarm bell went off i removed fuse and battery only to find out the bell box had its own battery.

What shows now when you try to reset it ? ( make sure front is back on )
You cannot reset it, i have tried before, all LEDs are red, does not respond to any reset or command.

The link was probably a spare in the bottom of the panel ....
Not too sure, i assumed it was connected as all the alarm panel is lit up red and not responding to anything when i reconnect the power and front.
 
Ok step by step remove bell + wire ( red) power up panel mains only ...no battery ...internal alarm should sound ....if so enter your 4 digit code ....does it stop ? If not enter 01234 does it stop ?
Then post back ...
 
tried this after the bell went off twice before. I disconnected the bell to stop it annoying neighbours, powered it all back up. All lit up red. every light, power, reset, tamper etc all red. I need to some how figure out what this all red error means
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top