Alarm system

[Lookin4answers]

Does anyone know what the "small link" should look like for the Challenger AP 200 alarm system and where I can get one from ?

The system is in place but I need to re-set the user settings back to factory settings and can't do this without the "small link" that attaches to the double pin memory plug on the circuit board...

Thanks

 

[plugwash]

I don't know that particular panel but it sounds like what you want is a jumper shunt.

http://www.maplin.co.uk/Module.aspx?ModuleNo=34146&C=Maplin&U=SearchTop&T=JUMPER&doy=22m10

also a heap of computer scrap should contain ****loads of the things.

 

[Lookin4answers]

Thanks looks like it may be an option I will contact Maplin's...

Any idea what the other end of the connection should be connected to if anything ?

 

[securespark]

The purpose of such an item is to join together (or not, as the case may be) the two pins on the PCB.

 

[Lookin4answers]

Make sense, thanks...

 

[Lookin4answers]

Sorry, makes sense - thanks...

 

[Lectrician]

It is usuall to just hold a screwdriver across the pins during power up to reload the factory defaults.

 

[Lookin4answers]

Sounds like a simple solution will try - thanks again !!!

 

[Lookin4answers]

Worked a treat, thanks again !!!

 

[Lectrician]

Typical over engineered answers on this forum.....