Hi all,
I have referred to many threads on here regarding installation of a dual channel Hive.
I bought the necessary Hive and know it needs to be set to gravity fed.
I took the front of the Danfoss 103 to reveal this :
This is what is behind the Danfoss 103 panel :
The Danfoss 103 is connected to this thermostat in the hall :
This is the Hive, I need to connect the wires from the Danfoss 103 to this :
I have read that the thermostat either needs to be removed completely or can be left connected with the thermostat on full.
I would like to remove the thermostat in the hall completely so I can put my Hive controller there.
I would appreciate any help given. I am aware the earth goes to earth tether and N and L goes to Hive N and L but there are multiple wires in 5 and 6 and I'm not sure which is which.
Cheers!
I have referred to many threads on here regarding installation of a dual channel Hive.
I bought the necessary Hive and know it needs to be set to gravity fed.
I took the front of the Danfoss 103 to reveal this :
This is what is behind the Danfoss 103 panel :
The Danfoss 103 is connected to this thermostat in the hall :
This is the Hive, I need to connect the wires from the Danfoss 103 to this :
I have read that the thermostat either needs to be removed completely or can be left connected with the thermostat on full.
I would like to remove the thermostat in the hall completely so I can put my Hive controller there.
I would appreciate any help given. I am aware the earth goes to earth tether and N and L goes to Hive N and L but there are multiple wires in 5 and 6 and I'm not sure which is which.
Cheers!