Hi Can anyone shed light on this problem? I've read many threads on this topic but have been thrown a curve ball by Heatteam (Baxi Tech)
Basically, the hot water will operate for around 30 seconds then cuts out for 10 seconds then refires etc - continual cycle. The diaphram operates the microswitch fine, pump runs and fan operates. The heated water pushes round the CH when that's not in demand.
Heat team seem to think it's either the heat plate or the 3 way valve. It is not a hard water area.
Has anyone experienced the same problem & if so which part is the more likely culprit?
Basically, the hot water will operate for around 30 seconds then cuts out for 10 seconds then refires etc - continual cycle. The diaphram operates the microswitch fine, pump runs and fan operates. The heated water pushes round the CH when that's not in demand.
Heat team seem to think it's either the heat plate or the 3 way valve. It is not a hard water area.
Has anyone experienced the same problem & if so which part is the more likely culprit?