Baxi 105e - Whats this part and could it cost £200?
- Thread starter ACIDTECHNO
- Start date
Think I'll try British Gas.
[quote="ACIDTECHNO";p="1513340
Tap is fine. When I turn tap on, it depends how far I open it, as to what happens. If I open it fully like I used to, I get lots of cold water. If I leave it at a trickle, I get nice hot water trickling into the bath.
My only expectation is that the heating system should work like it has done since it was installed. One day I had gallons of hot water supplied to shower and bath, next only cold unless it's a trickle.
Thanks for suggestion re pressure / rates etc.[/quote]
I am sorry but as an engineer, the work "trickle" does not have any definition.
Can you measure the flow rate in litres per minute which represents the maximum flow rate that you can only JUST keep your hand under.
Tony
Tap is fine. When I turn tap on, it depends how far I open it, as to what happens. If I open it fully like I used to, I get lots of cold water. If I leave it at a trickle, I get nice hot water trickling into the bath.
My only expectation is that the heating system should work like it has done since it was installed. One day I had gallons of hot water supplied to shower and bath, next only cold unless it's a trickle.
Thanks for suggestion re pressure / rates etc.[/quote]
I am sorry but as an engineer, the work "trickle" does not have any definition.
Can you measure the flow rate in litres per minute which represents the maximum flow rate that you can only JUST keep your hand under.
Tony
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
