Right then. Well the boiler stopped working because the water pressure went to minimal (must be a slow leak somewhere, does this gradually over the course of the year). So I re-applied pressure to around 2, but the unit is still not operational.
Now normally if the pilot light goes out this will be indicated on the front panel (apparently this can happen when the pressure gets too low?) but this is not the case, so I took the cover off finally and I can not see any pilot light lit either! So perhaps the LED or whatever the light uses in that panel to indicate the pilot light is off has blown out, because I can't see any flame at all with the lights out.
So basically I would like to know how to manually re-ignite the pilot light, reset button does no good at all.
Now normally if the pilot light goes out this will be indicated on the front panel (apparently this can happen when the pressure gets too low?) but this is not the case, so I took the cover off finally and I can not see any pilot light lit either! So perhaps the LED or whatever the light uses in that panel to indicate the pilot light is off has blown out, because I can't see any flame at all with the lights out.
So basically I would like to know how to manually re-ignite the pilot light, reset button does no good at all.