Hi all,
New to the forum - wondering if someone could help.
I've just moved to a new house with a Baxi combi boiler - not sure whether its the 80e or the 105e model but its one of the two. Its a couple of years old.
When I set the boiler to CH/HW mode, heating kicks in and rads heat up and all is ok, but when i open a hot water tap it switches to HW mode to provide hot water on demand and CH mode is interrupted. This is all fine and as expected according to the instructions manual, however after hot water tap is turned off, the boiler remains in HW mode and never reverts back to CH. The instructions manual doesn't make any mention of this either. Is this how its meant to be or is there a fault or something I'm not doing riigt? I can't believe that it would be setup so!?!?
There is also a CH temp control, this doesn't make any difference to the operation (other than temp). There is also a HW pre-heat control which if turned on, will cause the boiler to first heat up the water then switch to CH (in CH/HW mode), but once again if hot water tap is tuned on, it reverts to HW and stays there regardless - surely after H/W tap is turned off and there is no more demand for it, it should revert to CH as its in the CH/HW setting??!?!?
Please help.
Thanks.
New to the forum - wondering if someone could help.
I've just moved to a new house with a Baxi combi boiler - not sure whether its the 80e or the 105e model but its one of the two. Its a couple of years old.
When I set the boiler to CH/HW mode, heating kicks in and rads heat up and all is ok, but when i open a hot water tap it switches to HW mode to provide hot water on demand and CH mode is interrupted. This is all fine and as expected according to the instructions manual, however after hot water tap is turned off, the boiler remains in HW mode and never reverts back to CH. The instructions manual doesn't make any mention of this either. Is this how its meant to be or is there a fault or something I'm not doing riigt? I can't believe that it would be setup so!?!?
There is also a CH temp control, this doesn't make any difference to the operation (other than temp). There is also a HW pre-heat control which if turned on, will cause the boiler to first heat up the water then switch to CH (in CH/HW mode), but once again if hot water tap is tuned on, it reverts to HW and stays there regardless - surely after H/W tap is turned off and there is no more demand for it, it should revert to CH as its in the CH/HW setting??!?!?
Please help.
Thanks.