-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Beam and block detail suggestions
- Thread starter firapara
- Start date
Why haven't you got a dpm like the detail that other bloke posted?
DPM will go under the insulation on top of the floor, blocks.
Assuming your dpm will go under the insulation and lap up under the sole plate there's not a lot of difference between the two is there? You'll just need to ensure the beams have the required bearing. Why is there an additional dpc beneath the beams?
We did ours much like your first illustration.
Of course until the building is rendered, water will track along the beam in either case.
Looking end on at the beams, I found using concrete bricks with a generous bed of mortar filled the gaps between the block work below and the floor blocks. And fitted a few of the gaps with flat vent piope for ventilation of the sub-floor.
Of course until the building is rendered, water will track along the beam in either case.
Looking end on at the beams, I found using concrete bricks with a generous bed of mortar filled the gaps between the block work below and the floor blocks. And fitted a few of the gaps with flat vent piope for ventilation of the sub-floor.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
