- Joined
- 17 Aug 2010
- Messages
- 2,762
- Reaction score
- 573
- Country
I have a couple of 'sack barrow' type wheels with needle bearings that I would like to use. The internal measurement given for the bearing is 20.66 mm. Its is obviously too slack on a 20mm bar. I guess the strange size of 20.66mm is likely to be old 13/16th of an inch (which works out at 20.64) ??
Is bar of this dia going to be available ? or would I need to turn something down on a lathe ?
No wonder I was given the wheels free....
any thoughts ?
Is bar of this dia going to be available ? or would I need to turn something down on a lathe ?
No wonder I was given the wheels free....
any thoughts ?