I have just been asked to upgrade a Zone 2 bathroom light. I took the old one down to discover 5 grubby cables (loop in & out, switch, fan, mirror light, latter two from switched feed) all connected with plastic connector blocks and covered in tape. This arrangement was stuffed into a very small hole in the ceiling. It all looks v dodgy and I need to improve on this somewhat. In fact, the neutral from the mirror light was connected to the other cpcs with its own cpc disconnected!?!
Anyway, I'm thinking that a JB is required here, but there's not much room. Access from above has been ruled out. Any suggestions, guys? (I guess I could enlarge the hole in the ceiling and fit a small 4-terminal jb...).
(This domestic sparky malarky can be a pain - should've stayed on the rigs. At least the cabling was neat! ).
Anyway, I'm thinking that a JB is required here, but there's not much room. Access from above has been ruled out. Any suggestions, guys? (I guess I could enlarge the hole in the ceiling and fit a small 4-terminal jb...).
(This domestic sparky malarky can be a pain - should've stayed on the rigs. At least the cabling was neat! ).