Hi guys.
The title may be a little misleading but essentially sums up what i need to do.
Please take a look at the picture attached. I need to drill or make a neat hole big enough to fit 20mm conduit in the slab below the rubber grommet, with the edge of the hole only a few mm away from the wall of my shed.
I have a 90 degree drill - the chuck makes the hole too far away from the wall unless i drill at an angle (trying to avoid).
I have a 90 degree chuck attachment - same issue as above.
I considered using a multi tool with a tile bit, but unsure if that will do it, and if so, if it will leave it neat.
How would you guys do it?
Is there a special tool in existence?
Thanks
The title may be a little misleading but essentially sums up what i need to do.
Please take a look at the picture attached. I need to drill or make a neat hole big enough to fit 20mm conduit in the slab below the rubber grommet, with the edge of the hole only a few mm away from the wall of my shed.
I have a 90 degree drill - the chuck makes the hole too far away from the wall unless i drill at an angle (trying to avoid).
I have a 90 degree chuck attachment - same issue as above.
I considered using a multi tool with a tile bit, but unsure if that will do it, and if so, if it will leave it neat.
How would you guys do it?
Is there a special tool in existence?
Thanks