boiler break down can u help

[acso]

P.S. Also check the venturi's on the fan for any blockage. Could just be that. Ok

 

[Agile]

P.S. Also check the venturi's on the fan for any blockage. Could just be that. Ok

Do you really think thats its safe to encourage a DIYer without gas skills or training to open the combustion chamber and meddle with the APS or venturi?

Tony

 

[algeep]

who said diyer

 

[namsag]

Algeep had one last week on a 105e that everything said air pressure switch but it was the venturi it had slightly distorted with heat, and was not allowing the correct air flow.
Not sure if the HE uses the same venturi as a standard boiler though

 

[Celtgas]

hi, new to this!! but definitely 99 times out of 100 will be the air pressure switch.

 

[namsag]

Cant be that new if you have done a hundred of them

 

[Agile]

No.......but this is one for the combustion chamber i think.

If you are CORGI registered then, as you were informed, at the beginning you should have posted this in the Combustion Chamber so that we could safely give you any advice that was appropriate.

Neither your posting nor you profile indicates that you are professionally engaged in boiler repairs.

Its such a basic problem that if you are indeed qualified then you seem very inexperienced.

Tony

 

[gigz]

Make sure the flue is fitted correctly and inner flue is pushed fully home.

 

[algeep]

agile me old cock your right i am very inexperienced and have just applied to join combustion chamber thing with a corgi is your not taught through bgu program or acs exactly how to fault find its just safe working practices for fluing venting and gas but if someone calls you out saying hot and cold water fluctuations or something your basically knackered until you get more experience and thats where you guys come in keep the comments coming

 

[algeep]

question for admin havnt heard yet about combustion chamber acceptance or not and how do i access the forum

 

[Agile]

You need to send it as an email to [email protected]