Hi
I have loads of cabinet handles to put onto cabinets and I have purchased a jig which doesn't appear to be square, I have tried adjusting it (its cheap but had good reviews etc) to no avail.
When I set it up and draw a line, I can see from using a square that it is not at 90 degree which is disappointing. I have tried using masking tape to level it but to no avail.
Is there a tool that is likely to work for this or is there another way of doing this easily. I was really hoping this would work but just isn't doing it.
How does everyone do these? Masking tape and a square? Going to take a while.
I have loads of cabinet handles to put onto cabinets and I have purchased a jig which doesn't appear to be square, I have tried adjusting it (its cheap but had good reviews etc) to no avail.
When I set it up and draw a line, I can see from using a square that it is not at 90 degree which is disappointing. I have tried using masking tape to level it but to no avail.
Is there a tool that is likely to work for this or is there another way of doing this easily. I was really hoping this would work but just isn't doing it.
How does everyone do these? Masking tape and a square? Going to take a while.