I am currently about to have fitted an AEG induction hob, model HK654200FB
The technical data in the supplied AEG docs reads :
Model HK654200FB
Typ 60 GAD D5 AU
Induction 7.4kW
PNC 949 597 199 00
220-240V 50-60Hz
Cooking Zones / Nominal Power (maximum heat setting) [W] / Power Function [W]
left front / 2300 / 3700
left rear / 1800 / 2800
right front / 1400 / 2500
right rear / 1800 / 2800
The hob is situated approx within 3m distance of the RCD board
The doc also mentions :
Connection Cable - "For a single phase ot two phase connection, use the cable type H05BB-F or H03V2V2-F which withstands a temperature of 70c or higher"
Can anyone confirm for me please :
The technical data in the supplied AEG docs reads :
Model HK654200FB
Typ 60 GAD D5 AU
Induction 7.4kW
PNC 949 597 199 00
220-240V 50-60Hz
Cooking Zones / Nominal Power (maximum heat setting) [W] / Power Function [W]
left front / 2300 / 3700
left rear / 1800 / 2800
right front / 1400 / 2500
right rear / 1800 / 2800
The hob is situated approx within 3m distance of the RCD board
The doc also mentions :
Connection Cable - "For a single phase ot two phase connection, use the cable type H05BB-F or H03V2V2-F which withstands a temperature of 70c or higher"
Can anyone confirm for me please :
- The correct fuse rating required on the board
- What thickness supply cable needs to be run from the board to the hob
- Is a separate connection cable actually required, or can the grey supply cable be hardwired to the hob, assuming there is enough spare