I have just replaced my kitchen sink with a 1 1/2 bowl sink. The traps are 40mm compression fitting but the existing waste pipe is push fit. I am not able slide the compression fitting 'nuts' over the push fit pipe as the outside diameter is too big. Are conversion fitting available to enable this to happen. Alternatively are push fit traps available, if so where from?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
compression fitting trap to push fit pipes
- Thread starter garyslater
- Start date
If it is 'old' waste pipe then you could be on an impossible search. Years ago nearly every type/colour and manufacture of waste pipes had their 'own' sizes. Can you take a peice of your existing waste into local plumbers merchant to try to find a fitting that will fit 
New waste pipe is only a couple of quid
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
