Hi All,
Been out to buy everything I think I need to do the plumbing in my DIY bathroom re-fit today - I will never again say plumbers are expensive after seeing the cost of the bag full of plastic and copper bits!
I'm fitting a new towel rail to existing 8mm microbore and have bought 15mm x 8mm fitting reducers to let me connect into some 15mm valves.
The 15mm end doesn't seem long enough to me - is it just a case of getting the olive seated in the middle of the 15mm end even though it doesn't push all the way into the valve or am I missing something?
Wondering if I should have just bought couplers and connected to a short length of 15mm pipe.
Been out to buy everything I think I need to do the plumbing in my DIY bathroom re-fit today - I will never again say plumbers are expensive after seeing the cost of the bag full of plastic and copper bits!
I'm fitting a new towel rail to existing 8mm microbore and have bought 15mm x 8mm fitting reducers to let me connect into some 15mm valves.
The 15mm end doesn't seem long enough to me - is it just a case of getting the olive seated in the middle of the 15mm end even though it doesn't push all the way into the valve or am I missing something?
Wondering if I should have just bought couplers and connected to a short length of 15mm pipe.