Connecting switch to LED driver

[DIWhat]

Hi,

I have a double pole light switch which is wired to a twin and earth 2.5mm cable. I want to connect an led driver to this cable.

The driver is a dimmable driver, so at some point I may change the switch to a dimming switch but not to start off with.

What would be a sensible way to connect the cable and driver together?

Would something like this be ok...

https://www.saving-light-bulbs.co.uk/led-ceiling-lights/junction-box/3-pin-push-fit

The cable and driver will be kept above my kitchen cabinets.

 

[PrenticeBoyofDerry]

Yes those connectors will do.

 

[DIWhat]

Great thank you!

 

[ban-all-sheds]

The driver is a dimmable driver, so at some point I may change the switch to a dimming switch

You're sure that that is how dimming is controlled?

BTW - ignore any tw@s who pop up banging on about what a driver is, or is not.

 

[DIWhat]

It was purchased as such, but now i'm wondering about that.
Here's a picture of it:

 

[ban-all-sheds]

And that is dimmable?

How?

 

[333rocky333]

That type of driver tends to use a further box between the output and the leds to do the dimming, that extra box is not usually something that can be controlled by a standard mains voltage dimmer

 

[bernardgreen]

BTW - ignore any tw@s who pop up banging on about what a driver is, or is not.

Looks like this manufacturer labelled the product correctly,

come on BAS tell us where the word transformer can be found

 

[ban-all-sheds]

Not on that.


But so what?