I'm installing a magnetic door contact on the side door of my garage.
The instructions show the red and black wire going to the silver contact and the yellow and blue to be twisted together and go to one of the brass contacts. It then shows that the red and black go to the appropriate zone in the control panel unit.
However, I'm unsure from the diagram in the manual where the blue and yellow terminate. Should they terminate at the tamper terminals or terminate separately or together using a connector strip?
Thanks
The instructions show the red and black wire going to the silver contact and the yellow and blue to be twisted together and go to one of the brass contacts. It then shows that the red and black go to the appropriate zone in the control panel unit.
However, I'm unsure from the diagram in the manual where the blue and yellow terminate. Should they terminate at the tamper terminals or terminate separately or together using a connector strip?
Thanks