I have some copper pipes (hot and cold feeds) that have been wrapped in denzo tape and then screeded over (no other sleeves or protection). Only a relatively small area close to where the cylinder will be based has been done so far.
Just wanted to check if:
(i) this is okay for this area
(ii) okay, but preferably should be done another way...
(iii) is likely to be a problem
Advice appreciated.
Thanks
Just wanted to check if:
(i) this is okay for this area
(ii) okay, but preferably should be done another way...
(iii) is likely to be a problem
Advice appreciated.
Thanks