Creating utility area

[pmd1]

Hi All,

We have some space at the back of our garage where we currently have a freezer, washer and tumble dryer and I'd like to smarten it up a bit.

The garage is made of sectional concrete panels so I'm looking at boarding the back bit out. I was planning on painting the inside of the wall with blackjack DPM (or similar), then some foil backed insulation and then lining the inside of the board (OSB) with some normal DPM sheets before putting it on the stud work.

Does this seem about right?

Cheers

 

[foxhole]

Insulation is pointless unless you heat the garage and insulate all of it .