I have the DCF887 about 5 years old and trying to remove some 5x200mm screws it's not budging them even on the highest setting with a full battery... Lots of noise, no turning off screws. I've had to start using a socket wrench with a 10" handle to loosen them half a turn first but with ~300 that's going to be slow.
Is it possible mine could be on the way out or do I just need something more powerful? I'm not sure what the equivalent model is these days.
The screws are through 20mm ply, 120mm PIR into softwood and were installed using an equivalent tool.
Is it possible mine could be on the way out or do I just need something more powerful? I'm not sure what the equivalent model is these days.
The screws are through 20mm ply, 120mm PIR into softwood and were installed using an equivalent tool.