Does anyone know about the Gledhill Systemate 2000?

[gledhill]

had a water burst beteen the boiler and my systemate... changed the boiler pump.
Now

the boiler is sending H-water to the Gledhill system and the primary flow is pumping to the Rads, but the stored water is not getting hot when i run the taps the HW LED (bar3) light and goes off, on , off. the 3 green LEDs all show perminently.
worse still if i turn the thermostat down for the central heating the HW from the boiler has no were to go and it seems like it may blow again with the boiler and pipes knocking and banging again.

 

[nickso]

hmm, bit confusing this

you had a burst pipe? and you changed the pump?

the thermostat on the boiler should always be set to max otherwise the systemate may never reach its set store temp.

 

[BigBurner]

The Systemate is a DHW only thermal store, but the controls control the CH as well.

The boiler and boiler pump (CH pump really) is switched on by the Systemate. The DHW pump is switched on by the Systemate too, along with the boiler. Check that temperature sensing probes have been inserted properly.

A burst? Pump? More details needs.