double trouble

hi all, im going to attempt to change a single rad to a double only trouble is the double needs to be 20mm further away from the wall ie 60 mm instead of 40 mm ..the pipes come horizontly out of the wall to the valves there isnt enough room to extend them so is there a fitting i could use
the pipework is smaller than 10mm whats the next size down 8mm ? cheers P M

 

Push the nuts back into the wall (dig if required) and cut the olives and break them off. Then you can use solder fittings. 8mm ones are very short!

 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Please select a service and enter a location to continue...

Plumber / Gas Engineer Electrician Builder Decorator Builders' Merchant Plumbers' Merchant Tile Supplier Flooring Supplier
Start Search

Are you a trade or supplier? You can create your listing free at DIYnot Local