Enforcer - Opm-00 485 Fail Opm

[ykes]

Hi my first time here; I have tried to find answers on this already; I apologise in advance if I have missed it....

Anyone come across this message before on an Enforcer 32:

"Opm-00 485 Fail Opm"

Was checking inside the control panel for any bell wiring issues and put the panel back on exited the and and got this.
(As had a random alarm for two items together a shock sensor and bell tamper (33).
Viewed inputs, end stations, shows 'cF' input (33) (1) 02.1k, input (34) (2) > 25.3k

Have checked all connectors, fuses, reset ribbons and did not short anything out.

It will not clear.

Thanks for any pointers.

Lee

 

[sparkymarka]

Zone 34 is in fault ...what’s on z34 ?

 

[ykes]

I understand to be the bell box, all wireless bar that being hard wired.
Since it's now showing bell tamper 33, as well as the OPm fail, renamed input 0 to the key pad and it shows the Opm message twice now with Kpd on the end of it.

Seems weird ..

 

[sparkymarka]

Are you sure the fuse hasn’t blown on the input board ?

 

[ykes]

Thanks, just checked them again and ok, think I'm going to swap out the bell box and take it from there.

Thanks for your help

 

[sparkymarka]

Try powering the panel down and power back up ....what bell box do you have connected to the op board ?