Hi all
I am new to this but am very appreciative of all the technical advice that is been given. I am looking to install a new hive system and replace the ep2001 controller. I have read a lot of threads and that are all different to each other due to the spring configuration.
From what I can gather I need to do the following.
Old - new
A - connector block
B- connector block
D - connector block
N - N
5 - L (remove link)
1 - DONT KNOW
3 - 3
4 - 4.
There is a control box in the airing cupboard which connects the circulation pump, cylinder stat and 3 way valve - I take it there is nothing do in this area
Room stat remove and connect the yellow and red and isolate the blue.
Any assistance greatly appreciated.
I am new to this but am very appreciative of all the technical advice that is been given. I am looking to install a new hive system and replace the ep2001 controller. I have read a lot of threads and that are all different to each other due to the spring configuration.
From what I can gather I need to do the following.
Old - new
A - connector block
B- connector block
D - connector block
N - N
5 - L (remove link)
1 - DONT KNOW
3 - 3
4 - 4.
There is a control box in the airing cupboard which connects the circulation pump, cylinder stat and 3 way valve - I take it there is nothing do in this area
Room stat remove and connect the yellow and red and isolate the blue.
Any assistance greatly appreciated.
