Extending an appliance cable

I take the moulded leads off defunct washers and dryers and use those with a single 13A "rubber" socket to make my own high power, short, extensions for this sort of use.
I have a selection of similar short and/or repurposed appliance products, a few from the car at the moment:
1795174749062.png

Ringed in red were all removed from appliances,
Blue was a damaged extension lead
 
1795178317508.pngI looked at a random Beko drier BM3T3822W, Electrical connection 900 Watts Fuse Rating 4 amps that would run with any supply. But a DTKCE80021W shows Electrical connection 2700 Watts Fuse Rating 11.5 amps I do wonder where one would find a BS 1362 fuse of 11.5 amps.

So it says very little about the drier just saying Beko or made in Turkey etc. I know my vented had two settings and was around 2000 watt on high and 1000 watt on low, we always used it on low setting. It used less kWh that way.

I would not worry using my tumble drier on an extension lead. Ratting is 650 watts.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top