FITTING NEW RADIATOR 10MM CENTRAL HEATING SYSTEM

HI ,I NEED TO FIT A NEW RADIATOR TO MY CENTRAL HEATING, IT AS EITHER 8MM OR 10MM COPPER PIPE AND BOTH FEED AND RETURN CONNECT TO ONE END OF THE RADIATOR- FITTED AROUND 1983,I WANT TO FIT A NEW RADIATOR WITH A TRV ,FEED IN ONE END RETURN IN THE OTHER END,IT IS FITTED WITH A WORCESTER BOSCH 35CDi COMBI.
THANKS ELLSIE.

 

so whats the question ?

 

HI,WHAT PARTS DO I NEED AND HOW DO I GO ABOUT IT ,ELLSIE

 

measure the diameter of pipe,order approprite fittings and pipe....i.e 8mm pipe ull want 8mm compression fittings and 8mm pipe-or soldered fittings if u can solder,fit rad and repipe to the other end

 

So you planning to run 2 radiators off this (possibly) 8mm supply installed around 1983?

 

HI, I JUST WANT TO FIT A RADIATOR WITH A TRV ,ELLSIE

 

wheres the 2 rads come into it ?

 

i was asking because i wasnt sure from the question if she meant she was connecting to an existing 10 or 8 supply, was it not ok to ask?

 

Of course it is OK to ask.
Moreover has the OP the skills/knowledge to do this?
Anyone for a flood claim?

 

HI, THANKS FOR ALL YOUR HELP,ALL I AM TRYING TO DO IS REPLACE AN OLD RADIATOR ON A 10MM SYSTEM -WHERE BOTH INLET AND OUTLET PIPES RUN INTO ONE END OF THE RADIATOR,FOR A NEW ONE, SO I CAN FIT A TRV AND HAVE INLET IN ONE END AND OUTLET IN THE OTHER ,A TRV CANNOT BE FITTED WHEN BOTH PIPES RUN TO THE SAME END.ELLSIE

 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Please select a service and enter a location to continue...

Plumber / Gas Engineer Electrician Builder Decorator Builders' Merchant Plumbers' Merchant Tile Supplier Flooring Supplier
Start Search

Are you a trade or supplier? You can create your listing free at DIYnot Local