Right thanks for this. So when you mean over sailing, does this mean you set your brick course back say 10mm off the base i have created ? In my photo you can see the exterior leaf is at the finished external ground floor level (patio will be level with this course of brick). I thought it would be best to do this course in my facing brick in case any was showing, but it should all be hidden really.
So my next course up will be the start of the seen external leaf.
My front section is actually 80mm wide tapering down to 70mm, so i am planning on knocking this course out and redoing it at the correct width. I have actually gone inwards a lot more than the other 2 walls and it is all down to the conservatory foundation putting me off line. I can actually see where i have moved inwards quite a bit at the far end.
So to bring the wall out by 30mm i think i will just take out that first course of facing brick and build up off the foundation to give me a good base. This way i can accommodate the extra thickness of my brick as well. I have made the building 100mm shorter than planning just in case of a cock up.
So my next course up will be the start of the seen external leaf.
My front section is actually 80mm wide tapering down to 70mm, so i am planning on knocking this course out and redoing it at the correct width. I have actually gone inwards a lot more than the other 2 walls and it is all down to the conservatory foundation putting me off line. I can actually see where i have moved inwards quite a bit at the far end.
So to bring the wall out by 30mm i think i will just take out that first course of facing brick and build up off the foundation to give me a good base. This way i can accommodate the extra thickness of my brick as well. I have made the building 100mm shorter than planning just in case of a cock up.