I have been given a 5 speed Dremel, 125watt. I want to control it using a foot switch. Can I use a variable speed foot switch (if I put it on max speed setting) or can I only use an on-off foot switch please?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Foot switch for Dremel?
- Thread starter Henpecked1
- Start date
Just a speculation, but I would think if you reduced the revolutions of your Dremel by using a resistive foot switch you'd be left with very little power to do the job.....better just have an off/on one I'd guess.
John
John
- Joined
- 27 Apr 2008
- Messages
- 10,137
- Reaction score
- 1,152
- Country
I'm not so sure about that, ISTR that Dremels etc. are speed controlled by the voltage applied to them. (or is it PWM?)
However see https://www.dremel.com/en-us/custom...?prod=MultiPro Single and Two Speed Tools#205
Me, I'd be looking at getting the foot switch control the PSU to vary the voltage supplied to it, not from 0v-max but from enough to provide a slow speed without knackering the drill.
If you look atthe variable speed dremels, they appear to have a potentiometer on the front panel - get the foot switch to replace this and it may work.
Would need some electronics though - and very dependent upon your drill model.
One thing though, absolutely do not attempt at varying the mains input!
However see https://www.dremel.com/en-us/custom...?prod=MultiPro Single and Two Speed Tools#205
Me, I'd be looking at getting the foot switch control the PSU to vary the voltage supplied to it, not from 0v-max but from enough to provide a slow speed without knackering the drill.
If you look atthe variable speed dremels, they appear to have a potentiometer on the front panel - get the foot switch to replace this and it may work.
Would need some electronics though - and very dependent upon your drill model.
One thing though, absolutely do not attempt at varying the mains input!
Ok, thanks for your help. More complicated than I thought! Maybe I'll go to plan B and save up for a new drill!
Drill speed controllers use a THYRISTOR or a TRIAC. It used to be possible to buy these as ready-made external accessories.
http://www.ebay.co.uk/itm/SCR-Hi-po...ng-Speed-Control-Thermost-3KW-E-/291639371151
http://www.ebay.co.uk/itm/SCR-Hi-po...ng-Speed-Control-Thermost-3KW-E-/291639371151