Hi,
I'm new on here so apologies if my language isn't the most technical but here goes!
I've been building an alcove cupboard which was coming along fine until it came to cutting a frame. I used a jigsaw but the edges of the opening are not perfectly straight and was wondering if there was anything I could do to salvage it or whether it was possible to put trim around the edges of the opening to hide the slightly crooked cutting.
Any help would be greatly appreciated!
I'm new on here so apologies if my language isn't the most technical but here goes!
I've been building an alcove cupboard which was coming along fine until it came to cutting a frame. I used a jigsaw but the edges of the opening are not perfectly straight and was wondering if there was anything I could do to salvage it or whether it was possible to put trim around the edges of the opening to hide the slightly crooked cutting.
Any help would be greatly appreciated!