Hope someone can help a damsell in distress!
I had a worcester greenstar he condensing boiler fitted about 5 years ago - not sure of the model have been frantically looking for the manual this morning to no avail - i looked at the worcester website and it could be the 30/35 - mine does not have the pressure on display.
This morning the heating did not come on but the water did - the pipes into and out of the boiler were hot .
The temp has slowly been dropping on the display from 59 over an hour ago to 33 now - I have tried to reset the boiler by turning it off by the front and by the mains but still nothing.
When it is turned on it shows on the display as going from p2, p3 p4 and then showing 33 (now its 30). It isnt doing its normally "sparking" up which would when i would now it was coming on.
Apologies for the lack of terminology but my brain is frozen!
Can anyone help??
When i press and hold the button next to the triangle with an exclamation mark after 10 seconds it flashes red and shows fd in the display - this then clears after i press the same button again.
I cant seem to figure out how to spark the pilot light to get it into action!
thankfully the kids are at school today but i am sat here with gloves on!
All answers gratefully received
I had a worcester greenstar he condensing boiler fitted about 5 years ago - not sure of the model have been frantically looking for the manual this morning to no avail - i looked at the worcester website and it could be the 30/35 - mine does not have the pressure on display.
This morning the heating did not come on but the water did - the pipes into and out of the boiler were hot .
The temp has slowly been dropping on the display from 59 over an hour ago to 33 now - I have tried to reset the boiler by turning it off by the front and by the mains but still nothing.
When it is turned on it shows on the display as going from p2, p3 p4 and then showing 33 (now its 30). It isnt doing its normally "sparking" up which would when i would now it was coming on.
Apologies for the lack of terminology but my brain is frozen!
Can anyone help??
When i press and hold the button next to the triangle with an exclamation mark after 10 seconds it flashes red and shows fd in the display - this then clears after i press the same button again.
I cant seem to figure out how to spark the pilot light to get it into action!
thankfully the kids are at school today but i am sat here with gloves on!
All answers gratefully received