Help - Wire up a BellBox With Only Four Wires !

[Dparr]

I have replaced a old key setter alarm box which only needed 4 wires to the bellbox with a Friends old Scantronic 9448+ Panel And have Ordered a New Odyssey 3E Bell Box to use with it.

How do i link the Strobe so that it works with the Bell at the same time ?
Can it be done ?
Or do i just use the bell only and forget the strobe ?

Panel is :

TR
0V
12V
Bell
Str

BellBox

+ VE Suppy = A
-Ve Bell = B
Ve Tamper = C
0V = D
Ve Strobe = S

Thanks David

 

[Alarm]

At the sounder put a link from the bell/sounder trigger to the strobe.
When it rings the strobe runs.

 

[Dparr]

Thank for the quick reply can you please show me using the
connection's below how the wireing would be with four wires

thanks Again

David


Panel is :
TR
0V
12V
Bell
Str

BellBox

+ VE Suppy = A
-Ve Bell = B
Ve Tamper = C
0V = D
Ve Strobe = S

 

[Alarm]

A - 12v
B and S - Bell
0v - 0v
TR - Ve Tamper

 

[Dparr]

Thanks Again for the superfast reply :
Just one more Question SAB Or SCB and which jumper settings

Battey is 2.1 amp 12 Volt Using only one Bellbox

The Odyssey 3e Bellbox Options are :


Battery on
Battery off

SAB Or SCB

Low Current On
Low Current Off


Thank You

Again

David

 

[Alarm]

Battery ON, this gives you the SAB capability.

SAB , see above. ( Basically if attacked it sounds, cable cuts, screws removed, ripped off wall).

LOW Current OFF, for use in multiple sounder situations or excessive current drain situations.

Good sounder , make sure both LEDS alternately flash when lid secured.