HIVE Single channel receiver issues on install

Hi,

I'm in need of some help.

I have been trawling the forum to find some solutions and have tried what has been suggested but still no luck.

I have an Ideal Logic ESP1 35 and Danfoss TP4000 thermostat/programmer

I have removed the Danfoss and have wired the Common into 1 and the NO into 3 on the hive back plate. When I turn power back on there is no Status Light flashing.

Am I right in thinking that I don't need to use the perm live and perm neutral as single channel?

Thanks in advance for any help!

 

Nope you have to put a live and neutral in to power the receiver and then use 1&3 as com and switched live from the boiler

 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Please select a service and enter a location to continue...

Plumber / Gas Engineer Electrician Builder Decorator Builders' Merchant Plumbers' Merchant Tile Supplier Flooring Supplier
Start Search

Are you a trade or supplier? You can create your listing free at DIYnot Local