- Joined
- 18 Aug 2016
- Messages
- 4
- Reaction score
- 0
- Country
Hi all. New to this forum, great site with very helpful advice.
I have just completed a new alarm installation but have only currently used an internal siren (SP20ST) and all works fine. I wired this into the PCB using the bell contacts and T/A for the tamper circuit.
I now wish to add an external siren (AG6) to the system.
My questions are:
1. Will the combined total current (600mA) be OK?
2. Wiring - Disconnect the SP20ST, wire in the AG6 as per the engineers manual, re-wire the SP20ST to the bell contacts using the zone tamper connections for its tamper circuit rather than the T/A contacts.
Thank you.
I have just completed a new alarm installation but have only currently used an internal siren (SP20ST) and all works fine. I wired this into the PCB using the bell contacts and T/A for the tamper circuit.
I now wish to add an external siren (AG6) to the system.
My questions are:
1. Will the combined total current (600mA) be OK?
2. Wiring - Disconnect the SP20ST, wire in the AG6 as per the engineers manual, re-wire the SP20ST to the bell contacts using the zone tamper connections for its tamper circuit rather than the T/A contacts.
Thank you.
