Honeywell g4 tamper lockout

[discovery3]

Hi guys new to this but replaced my old Honeywell g3 alarm as keypad buttons worn out so replace it with g4 version alarm and new bell box can anyone help me wire up my new bell box it’s a kinitic az220 alarm bell box to g4 alarm panel
Thanks guys

 

[secureiam]

A Supply -
B Bell TR -
D Supply +
T TAMP RT
Strobe - Strobe -

 

[discovery3]

This at moment we’re mine are but saying lockout on lcd

 

[secureiam]

Have you established where the tamper lock out is coming from?

 

[secureiam]

bell tamper, panel tamper keypad tamper?

if you place a link between T and A in the panel, this would rule out the bell tamper

 

[discovery3]

I take this scb a-t where my white and green wire is ?

 

[secureiam]

Yes, out of interest do you see any others on the panel?

 

[discovery3]

Just looped t-a and bell box siren goes off

 

[sparkymarka]

It’s wired wrong ….

 

[discovery3]

Tested each wire from panel to junction box in loft and every wire is tested and all good take panel out of engineering mode and goes back to tamper lock out going to look at bell box outside now

 

[discovery3]

Please help me you say it’s wired wrong

 

[discovery3]

Did find that put black wire in set screw place before I tested each wire

 

[discovery3]

Finally found it was the screw holding the bell box bending the backplate in top right screw which was the problem happy days
Micro switch was pressing down

 

[secureiam]

glad you find it and took the time to post the solution.