Hotpoint dishwasher design fault

A

angelfish2

I have just fixed my hotpoint dishwasher - the control wires that go from the front panel down to the water heater/pump is squeezed into a flimsy plastic tube which is then crushed between the door housing and the main body, thus being pulled and pushed everytime the door opens.

It seems a poor design to be honest and will always have a very limited life expectancy.
 
Sponsored Links
Its probably not the best method but that is how nearly all domestic dishwashers are wired up.

I have repaired 1 with this fault in the last 3 1/2 years and that was an integrated Hoover D/W.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top