- Joined
- 8 May 2017
- Messages
- 10,536
- Reaction score
- 2,810
- Country
Buy 2metre length or use a flexible waste pipe.
How am I supposed to tighten these tails going into Basin monobloc?
- Thread starter bilabonic
- Start date
Thanks so much for replying!!
I’ll do it in solid pipe I think then.
I’ve also ordered the 3/4” flexi with isolation for the bath taps.
I was just going to replace the old individual taps for a modern single one (they are 180mm spaced) as it would fit.
But looking at the new toilet and basin the bath now looks awful tbh!!
I think i may as well replace that as well.
Been googling about the sizes and it’s confusing.
Cheers
I’ll do it in solid pipe I think then.
I’ve also ordered the 3/4” flexi with isolation for the bath taps.
I was just going to replace the old individual taps for a modern single one (they are 180mm spaced) as it would fit.
But looking at the new toilet and basin the bath now looks awful tbh!!
I think i may as well replace that as well.
Been googling about the sizes and it’s confusing.
Cheers
- Joined
- 8 May 2017
- Messages
- 10,536
- Reaction score
- 2,810
- Country
What's confusing about bath sizes ??
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
