Hello guys, I'm trying to fit a new shower, but after taking my old shower bar valve off, it looks like this, long G1/2" male outputs coming out, and with all new shower instructions, I can't install an S connector, as it's not the correct pipe? These outputs go quite deep, about 7cm, the old valve was directly on them. Any help is appreciated, thank you.
How to fit a new shower bar valve with G 1/2" behind
- Thread starter asv321
- Start date
- Joined
- 8 May 2017
- Messages
- 10,485
- Reaction score
- 2,777
- Country
The picture may be deceiving ,but the threads look more like 3/4 BSP ,and not 1/2 inch.
What is their outer diameter ?
What is their outer diameter ?
It's approximately 20-21mm
- Joined
- 8 May 2017
- Messages
- 10,485
- Reaction score
- 2,777
- Country
Ok, not 3/4 then .
Any access behind the wall to alter pipework?
Any access behind the wall to alter pipework?
no access other than going into the wall
- Joined
- 8 May 2017
- Messages
- 10,485
- Reaction score
- 2,777
- Country
Other than fitting a coupler to convert 1/2 to 3/4 male ,(which would very likely result in the new shower valve sitting too far away from the wall for the chrome shrouds to cover the fitting and reach the wall), you should try to find shower valves that need 1/2 feeds.
What is the distance between the centres of the two threaded fittings ?
What is the distance between the centres of the two threaded fittings ?
it's 15cm, any suggestions will help me a lot, thank you
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
